You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Next »

This report provide an driver comparison, based on the transmiitted FMS/CAN messages.

Inhaltsverzeichnis

summary

content

The basis of the FMS/CAN - driver comparison are the recognized FMS/CAN messages of the detection device. (eg, distance, fuel consumption, ...). This report evaluate on the basis of these FMS/CAN messages with the stored comparison criteria over the evaluation period and output table for the selected sort criterion in any sort order.

requirements

  • supported hardware
  • hardware with enabled driver authentification
  • rate: Profi XXL

options of report

individual FMS/CAN - driver comparison

When creating a new FMS/CAN - driver comparison you select at least one and over a maximum of 8 comparison criterias, after that you want to provide the drivers. Therefor the tracking portal offers you an selection of already collated comparison profiles. This comparison profiles are an optional requirement to the typical evaluations for fuel consumption, usage,... .You can choose a ready comparison profile, or individually choose between the following comparison criteria.

compare criterias

distance

  • distance
  • Ø day distance
  • max. day distance
  • Ø tacho speed
  • max. tacho speed
  • overspeed warnings
  • Ø overspeed warnings

fuel consumption

  • fuel consumption
  • Ø fuel consumption

time

  • driven time ( vehicle in motion )
  • standing time ( time period without motion )
  • percentage drive time / total time
  • cruise control
  • percentage cruise control / drive time
  • ignition on ( It's not a FMS/CAN value. It is an telemetry value of the detection device It' s telemetry 7 = "ignition ON" . )
  • idle time ( time period without speed, but with engine speed higher 0rpm and ignition on )
  • PTO

other

  • number of brake entered
  • number of clutch entered
  • Ø engine speed
  • max. engine speed
  • Ø throttle position
  • max. engine coolant temperature
  • Ø engine coolant temperature

 

sort result

Beim Erstellen eines neue FMS/CAN - Fahrervergleichs kann man eines der ausgewählten Vergleichskriterien als Sortierkriterium definieren. Die ermittelten Ergebnisse werden dann nach diesem Kriterium in der Berichtausgabe sortiert. Bei der Sortierreihenfolge des Sortierkriteriums kann zwischen aufsteigend und absteigend gewählt werden.

Ausgabeformate

Dieser Report kann in folgenden Formaten ausgegeben werden:

  • HTML
  • PDF
  • Excel
  • CSV
  • No labels