Skip to Content

Wiki source code of Positionsfilter

Last modified by YellowFox_RD on 2024/12/19 10:12
Show last authors
1 (% class="box" %)
2 (((Table of Contents)))
3 {{toc/}}
4
5 The position filter makes it possible to limit the position messages displayed in the position list, according to different filter criteria.
6 = Filter dialog =
7 The filter dialog can be controlled in the position list by clicking on the gear wheel symbol [[image:image2016-11-30%2015%3A2%3A43.png]], to the right of the vehicle selection box.
8 A sub-menu opens, from which the entry "Filtern by…" should be selected.
9 [[image:image2016-12-1%208%3A51%3A28.png]]
10 Now the filter dialog opens.
11 But beware! "Filter by…" is only available if a vehicle was selected before!
12 == Possible filters ==
13 The following filters are available:
14 (((
15 * **Telemetry messages**: Show telemetry type position messages?
16 * **Configuration messages**: Show configuration type position messages?
17 * **FMS/CAN messages**: Show FMS/CAN type position messages?
18 * **Digitacho messages**: Show digitacho type position messages?
19 * **Status messages**: Show status type position messages?
20 * **Area messages**: Show area type position messages?
21 * **All other**: Show all other position messages?
22 )))
23  
24 == Filter selection ==
25 [[image:image2016-12-1%208%3A53%3A16.png]]
26 A filter is activated / deactivated by a simple touch or click.
27 Selected filters can be identified by a pre-selected check mark and a blue background color.
28 Once you have made your selection, use the green button above or below to apply the filters in the position list.
29 == Filter status ==
30 If a limitation of the displayed position messages via filters is active, this is indicated by an additional info bar below the vehicle selection box:
31 [[image:image2016-12-1%209%3A49%3A46.png]]
32 By touch or click on this bar, the containment can be canceled directly. (confirmation is required)
33