Use the Quick Search if you want to search position messages by types, time frames or objects.

QuickBar

Actions

	map display	= show the selected positions on map
	select positions	= select/ unselect positions to display them on map
	back	= start QuickSearch again
	export	= print/ export found position messages
	reset settings	= reset the settings to default
	display settings	= configure the display settings of the portal
	open help	= open the help for this topic
	QuickLink	= creates a Quicklink for this page

Search mask

A search by positions will affect to find position messages where a object was at a defined place.

If you want to search by address you must enter the post address and the searching radius at the next step. With this function it it for example possible to search for objects which were in the near of 12345 Berlin.

The function "use address from address book" enables the search by vehicle position by a address from the address administration. For example you can search how long a vehicles with the YF-hardware was in the near of a specific customer (address must be added to the address book).

Please note that the search by position is not available if the data lock is active.

Furthermore you can procced a search for one or ore objects. Just check the object, which you want to include to the search.

You are able to set the type of messages you want to search for. You can choose between telemtry and other messages. Telemetry messages are for example the ignition change messages. Other messages are for example intervall messages.

Please enter now the time frame you want to search.

All mentioned position messages are linked with an logical AND.

Result List

In the display you are able to select multiple messages to show them later on the map.

For that use either the selection function from the QuickBar or single check the message you want to show on the map. After that click in the map symbol from the QuickBar.