Position filter
Table of Contents
The position filter makes it possible to limit the position messages displayed in the position list, according to different filter criteria.
Filter dialog
The filter dialog can be controlled in the position list by clicking on the gear wheel symbol 
, to the right of the vehicle selection box.
A sub-menu opens, from which the entry "Filtern by…" should be selected.
Now the filter dialog opens.
But beware! "Filter by…" is only available if a vehicle was selected before!
Possible filters
The following filters are available:
- Telemetry messages: Show telemetry type position messages?
- Configuration messages: Show configuration type position messages?
- FMS/CAN messages: Show FMS/CAN type position messages?
- Digitacho messages: Show digitacho type position messages?
- Status messages: Show status type position messages?
- Area messages: Show area type position messages?
- All other: Show all other position messages?
Filter selection
A filter is activated / deactivated by a simple touch or click.
Selected filters can be identified by a pre-selected check mark and a blue background color.
Once you have made your selection, use the green button above or below to apply the filters in the position list.
Filter status
If a limitation of the displayed position messages via filters is active, this is indicated by an additional info bar below the vehicle selection box:
By touch or click on this bar, the containment can be canceled directly. (confirmation is required)