Here you can configure the Euroscan temperature writer behaviors.

Index

Summary

Here you can configure the Euroscan temperature writer behaviors. This includes the measured value monitoring interval and the meassure input configuration.

Message interval with ignition off

Here you can configure the time interval for getting meassure values for enabled Euroscan sensors with ignition off. If the ignition is of the required informations can only be send via a box while the box is not shut down. (see Shutdowntime) Usable values are: "off", "1 min", "2 min", "5 min", "10 min", "25 min" und "50 min". After a value change you must save the changes by using the SAVE button below the select box.

Configure the inputs

Each Euroscan input can be (de)activated and configured for it.

If the monitoring of a input is enabled/activated, you can change the following settings of it:

  • Valid from - to °C: Here the valid temperature range muste be defined, that does not trigger some messages. Always if the temperature goes outside the range defined here a message is send to connected box.
  • alarm after * seconds: Only if the temperature is ouside the allowed range for the seconds defined here (or for more seconds) a message was send.
  • Alarm cancel after * seconds: If the temparature is inside the allowed range the messages get disabled, if its was valid the last seconds, defined here.

Each input settings change must be saved by using the input appended "SAVE" button!

  • No labels